L.S. STARRETT

457C DIEMAKERSFT SQUARE WITH AN

STR52429 MFG #: 52429
$390.91 / EA
457C DIEMAKERSFT SQUARE WITH AN
  • Country of Origin: US
  • Graduations: 32nds - 64ths
  • Manufacturer Name: L.S. Starrett
  • Measuring Angle: 0 to 10 deg
  • Measuring System: Imperial
  • Series: 457
  • Thickness: 11/32 in
  • Tongue Size: 2-1/16 in
  • Width: 5/8 in
  • Size: 1-5/8 in L x 5/32 in W x 1/16 in THK
  • Material: Steel
The Starrett® 457 improved diemakers' square is a highly useful tool for tool and diemakers, especially for measuring die clearances. It is also very handy for patternmakers to check angles and drafts on patterns. The beam of this square is graduated to show the setting in degrees of the blades. Blades can be set for any angle upto 10 deg, either side of 0deg and the angle is indicated by the line on the pointer.
QTY
Add to List
  • Application
  • Item Features
  • Standards
For tool and diemakers, especially for measuring die clearances
  • The beam is beveled adjacent to the blade so that the blade is readily visible when checking in holes, slots, etc
  • Blades and beams are hardened and ground
  • It is also very handy for patternmakers to check angles and drafts on patterns
  • The beam of this square is graduated to show the setting in degrees of the blades
  • Blades can be set for any angle upto 10 deg, either side of 0 deg and the angle is indicated by the line on the pointer
  • Graduated blade, 32nds of an inch on one side and 64ths on other, it is 5/32 in wide over a length of 1-5/8 in and cut away at one end to a width of 3/32 in
  • The offset blade, which is used where it would be impossible to insert the straight blade, protrudes from the square about 1-1/2 in, it is 1/8 in wide and both sides of each edge are beveled to give visual line contact
PROP65: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm