SHRK FT 9 DEG, BAL 1/2X 6.30"

PARLH100A-50SF630-9 MFG #: H100A-50SF630-9

$447.00 / EA

QTY

Add to List

For CNC Machine Tool

For maximum gripping power with exceptional concentricity
The use of heat shrink tooling allows for greater speeds and feeds, better finishes, increased tool life and increased productivity due to its high speed machining capability and simplicity of use
Simple and fast to use the total time elapsed to remove one cutting tool and insert another is less than 10 seconds
Constructed with double tempered tool steel for exceptional durability and cycle life
No mechanical clamping devices are used with proper use, toolholder life should exceed that of standard end mill holders
Chip load distributed evenly along cutting edge of tool which results in longer tool life
Tool is gripped 360 deg along the entire length of the bore resulting in an evenly distributed clamping force and increased concentricity
Improved balance design with no moving pieces low centrifugal forces due to low holder mass
Coolant through holders require no special backup screws or seals
The interference fit between the ID of the toolholder and cutting tool shank forms the seal, preventing the coolant from flowing anywhere else except through the cutting tool
Balanced to G 2.5 at up to 25000 rpm refer to charts for each taper size
Standard holders have 4.5 deg angle nose for compatibility with most heat shrink machines