567 V-BLOCKS AND CLAMPS NO. 5

V-Block, Clamp, Forg, 1/4-24 Clamp x 2-1/8 Long Screw, Cap With Screw, Cap, Side Screw, Screw and 1/4-24 Thumb x 1-3/8 Long Screw

• The clamp is smaller than the outside width of the block, but has an adjustable side screw to support the block and prevent tilting
• The V at the stepped end is at right angles to the base and is handy for holding shouldered studs, pins, etc
• A clearance hole for drilling or removing dowel pins is provided in the block
• The block has four 3/8-16 tapped holes
• The block is hardened and precision ground
• The clamp is a strong forging
• Can be used on its base, on the end, or on either side
• Used for general shop use and layout work, as well as for holding stock in place during light duty milling, drilling and grinding operations
• All clamp screws have a hole to help secure the workpiece

PROP65: This product can expose you to chemicals including: Diisononyl phthalate (DINP)/which is known to the State of California to cause cancer and Di-isodecyl phthalate (DIDP)/which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov