278B 1IN CLAMP ONLY

For general shop use and layout work, as well as for holding stock in place during light duty milling, drilling and grinding operation

• All clamp screws have a hole to help secure the workpiece
• 1 in Dia hold capacity
• Precision ground to extreme accuracy
• vees are central, parallel and square with the ends and sides
• Hardened and ground steel construction
• Numbered in series so the vees in each set are always in alignment
• 1/4-20 tapped hole through the sides for attachment to an angle iron that can then be attached to a lathe faceplate or held by a magnetic chuck

PROP65: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm